Admin
En línea
Creo que no esta publicado, solo he visto este procedimiento con furios.. ahora con umt tambien se puede restablecer los 10 intentos.
Conectamos FTM, con bateria presionando vol- luego con el modulo qcfire de la umt presionamos FTM2EDL.
Luego reset efs, luego a NO para que haga reset partial y no pierda el imei.
El tlf se reinicia y listo..
Operation : Partial Reset EFS
Checking for existing devices...Found
Port : Qualcomm HS-USB QDLoader 9008 (COM79)
Driver Info : ZTE Corporation, zghsser.sys, 5.2104.1.2
Opening Port...OK
Init Handshake Sequence...OK
Hardware ID : E1009600 [8909] 00000400
OPK_DATA : D64F31F1F574B2C3A0A679CA104A03C0F20B4833F5E2F96A2B56AA09B374C8A6
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Firehose Loader...Done
Sending Loader [8909_044.ufl]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8909, eMMC, 8 GB
LU Count : 1 [0x00E90000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : ZTE Z835 [msm8909]
Software : Z835V1.0.0B13, 20170702.034315 [2017年 07月 02日 星期日 03:43:10 CST]
Android Ver. : 7.1.1
Patch Level : 2017-07-01
Saving EFS Backup.......OK
EFS Backup : EFS_ZTE_Z835_Z835V1.0.0B13_2017-07-01_180802_001349.ueb
Reset EFS (Partial).....Done
Operation Finished.
Conectamos FTM, con bateria presionando vol- luego con el modulo qcfire de la umt presionamos FTM2EDL.
Luego reset efs, luego a NO para que haga reset partial y no pierda el imei.
El tlf se reinicia y listo..
Operation : Partial Reset EFS
Checking for existing devices...Found
Port : Qualcomm HS-USB QDLoader 9008 (COM79)
Driver Info : ZTE Corporation, zghsser.sys, 5.2104.1.2
Opening Port...OK
Init Handshake Sequence...OK
Hardware ID : E1009600 [8909] 00000400
OPK_DATA : D64F31F1F574B2C3A0A679CA104A03C0F20B4833F5E2F96A2B56AA09B374C8A6
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Firehose Loader...Done
Sending Loader [8909_044.ufl]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8909, eMMC, 8 GB
LU Count : 1 [0x00E90000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : ZTE Z835 [msm8909]
Software : Z835V1.0.0B13, 20170702.034315 [2017年 07月 02日 星期日 03:43:10 CST]
Android Ver. : 7.1.1
Patch Level : 2017-07-01
Saving EFS Backup.......OK
EFS Backup : EFS_ZTE_Z835_Z835V1.0.0B13_2017-07-01_180802_001349.ueb
Reset EFS (Partial).....Done
Operation Finished.
Debes estar registrado para ver imágenes adjuntar
