🔓Unlock/Liberar Huawei Med-lx9 (y6p) Unlock con sigma

[servergsm]

Unlock Huawei Med-lx9 (y6p) via tespoint con sigma

1. usamos sigmakey en su ultima version y con pack 3 activado.
2. nos dirigimos ala ventana mtk y elegimos el modelo
3. yo elegi usar la opcion leer codigos.
4. con la bateria desconectada y con una pinza ponen el test point como en la imagen
que les dejo aqui de un colega..
5. esperar que sigma haga su magia, y a cobrar bien por su trabajo...

SigmaKey v.2.40.01
......... Sigma dongle 2.40, Initializing...OK
Pack 1: Activated
Pack 2: Activated
Pack 3: Activated
Pack 4: Not activated
Pack 5: Not activated
--------- 2021-02-10 06:13:42 ---------
SigmaKey 2.40.01 MTK: Direct unlock (Huawei MED-LX9)
Cancelled
--------- 2021-02-10 06:14:03 ---------
SigmaKey 2.40.01 MTK: Get unlock codes (Huawei MED-LX9)
Baseband Processor:MT6765, HW Rev. A.00, SW Rev. 0.00
Testing external RAM...DRAM, 3 Gb
Detecting flash...eMMC, Flash size: 58.27 Gb
Software IMEI: 8610020.......
Reading unlock codes...Done

 

[josephr]

con pandora al instante

 

[josephr]

[01-07-2023 16:05:48] Selected model: Huawei UNKNOWN
[01-07-2023 16:05:48] Operation: Unlock network
[01-07-2023 16:05:48] Software version: 4.2
[01-07-2023 16:05:48] Work ID: 76222
[01-07-2023 16:05:49]
[01-07-2023 16:05:49] Connect phone in BROM Mode
[01-07-2023 16:05:49] Waiting for device... OK
[01-07-2023 16:05:55] Driver: [MediaTek Inc.,wdm_usb,MediaTek USB Port_V1632,usb2ser.sys,3.0.1504.0]
[01-07-2023 16:05:55] Device found at COM35 [BROM]
[01-07-2023 16:05:55] Open port... OK
[01-07-2023 16:05:55] Send start cmd... OK
[01-07-2023 16:05:55] Get HW code from device... 0766
[01-07-2023 16:05:55] Get sec config... OK [000000E5]
[01-07-2023 16:05:55] Active sec flags: [SBC DAA]
[01-07-2023 16:05:55] Get HW & SW version from device... OK
[01-07-2023 16:05:55] HW VER: CA00, SW VER: 0000, HW SUB CODE: 8A00
[01-07-2023 16:05:55] Install LibUSB... OK
[01-07-2023 16:05:56] Open port... OK
[01-07-2023 16:05:56] Detect chip [MT6765]
[01-07-2023 16:05:56] Library Version [2]
[01-07-2023 16:05:56] Select platform... OK
[01-07-2023 16:05:56] Init BROM... OK
[01-07-2023 16:05:56] Force Charge... OK
[01-07-2023 16:05:56] Disable WatchDog Timer... OK
[01-07-2023 16:05:56] Advanced Bypass Security... OK
[01-07-2023 16:05:56] Waiting for device... OK
[01-07-2023 16:05:56] Driver: [MediaTek Inc.,wdm_usb,MediaTek USB Port_V1632,usb2ser.sys,3.0.1504.0]
[01-07-2023 16:05:56] Device found at COM35 [BROM]
[01-07-2023 16:05:56] Open port... OK
[01-07-2023 16:05:56] Send start cmd... OK
[01-07-2023 16:05:56] Get HW code from device... 0766
[01-07-2023 16:05:56] Get sec config... OK [000000E0]
[01-07-2023 16:05:56] Active sec flags: []
[01-07-2023 16:05:56] Get HW & SW version from device... OK
[01-07-2023 16:05:56] HW VER: CA00, SW VER: 0000, HW SUB CODE: 8A00
[01-07-2023 16:05:56] LibUSB installed
[01-07-2023 16:05:56] Detect chip [MT6765]
[01-07-2023 16:05:56] Library Version [2]
[01-07-2023 16:05:56] Select platform... OK
[01-07-2023 16:05:56] Init BROM... OK
[01-07-2023 16:05:56] Force Charge... OK
[01-07-2023 16:05:56] Disable WatchDog Timer... OK
[01-07-2023 16:05:57] Reopen port for libver2... OK
[01-07-2023 16:05:57] Get ME ID... OK
[01-07-2023 16:05:57] ME_ID = 0xFE954CD9, 0xA158BF7F, 0x3C0A6D79, 0x93F0A22B
[01-07-2023 16:05:57] Get Chip ID... [MT6765]
[01-07-2023 16:05:57] Get SOC ID... [CB8F8E805218F56EDA6A97B54AF402723C3FE0D7C80BC4B440392BF1F4885EE5]
[01-07-2023 16:05:57] Get sec config... OK [000000E0]
[01-07-2023 16:05:57] Load DownloadAgent... OK
[01-07-2023 16:05:57] Search DA... OK [7]
[01-07-2023 16:05:57] Send preloader... OK
[01-07-2023 16:05:57] Start preloader... OK
[01-07-2023 16:05:57] Checking preloader answer... OK
[01-07-2023 16:05:58] Send bootloader... OK
[01-07-2023 16:06:00] Start bootloader... OK
[01-07-2023 16:06:00] Wait for answer from bootloader... OK
[01-07-2023 16:06:00] Send SYNC signal... OK
[01-07-2023 16:06:00] Setup device enviroment... OK
[01-07-2023 16:06:00] Setup device parametres... OK
[01-07-2023 16:06:00] Receive DA SYNC signal... OK
[01-07-2023 16:06:01] Set DA parametres... OK
[01-07-2023 16:06:02] Get device connection agent... [BROM]
[01-07-2023 16:06:02] Get device info... OK
[01-07-2023 16:06:02] EMMC_ID: 0x150100475036424D4201F08DD03F87D3
[01-07-2023 16:06:02] Load EMI from phone... OK
[01-07-2023 16:06:02] Parse EMI config... OK
[01-07-2023 16:06:02] Init EXT RAM... OK
[01-07-2023 16:06:02] Send 2nd DA... OK
[01-07-2023 16:06:04] Get device info... OK
[01-07-2023 16:06:04] EMMC INFO:
[01-07-2023 16:06:04] EMMC_CNAME: GP6BMB
[01-07-2023 16:06:04] EMMC_ID : 0x150100475036424D4201F08DD03F87D3
[01-07-2023 16:06:04] EMMC_BOOT1: 0x0000400000 (4.00Mb)
[01-07-2023 16:06:04] EMMC_BOOT2: 0x0000400000 (4.00Mb)
[01-07-2023 16:06:04] EMMC_RPMB : 0x0001000000 (16.00Mb)
[01-07-2023 16:06:04] EMMC_USER : 0x0E8F800000 (58.24Gb)
[01-07-2023 16:06:04] RAM INFO:
[01-07-2023 16:06:04] INT_SRAM: 0x000003A000 (232.00Kb)
[01-07-2023 16:06:04] EXT_RAM : 0x00C0000000 (3.00Gb)
[01-07-2023 16:06:04] Checking USB status... USB_HIGH_SPEED
[01-07-2023 16:06:04] Read partitions info from phone... OK
[01-07-2023 16:06:04] Checking A/B state... OK
[01-07-2023 16:06:04] Read product info... error(3)
[01-07-2023 16:06:04] Read security partition from phone... OK
[01-07-2023 16:06:06] Read security files... OK
[01-07-2023 16:06:06] Read security files... OK
[01-07-2023 16:06:06] Read lock info... OK
[01-07-2023 16:06:06] Unlock... OK [DF1, UN]
[01-07-2023 16:06:06] Write lock info... OK
[01-07-2023 16:06:06] Write security partition to phone... OK
[01-07-2023 16:06:07] Network Unlock done!
[01-07-2023 16:06:07]